Skip to content
Zap Electrical & Data

Electrical Fault Finding · Parkdale

Electrical Fault Finding in Parkdale

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Homes built in the 1950s and 60s often still run on their original cable, and some have been extended so many times that the wiring tells several stories. Along Como Parade, older shop buildings with a flat upstairs or behind can share circuits in ways nobody expects. When a fault shows up in either, the job is to find which part of the installation is responsible. Eric tests methodically from the board outwards and explains what he finds before any repair is quoted.

About our electrical fault finding service

When one tenant's fault cuts power to the other

In some older shop buildings, the dwelling and the shop share a switchboard, or a circuit from one quietly feeds a light or outlet in the other. A faulty appliance in the shop can then trip the power to the flat, or the reverse, which leads to confusion over who caused it.

We trace what each circuit supplies, find the actual fault, and show the landlord where the two tenancies are tangled together, with written options for separating them. Where the landlord prefers, each tenancy can also be given its own meter so power bills are no longer shared.

Mid-century wiring that has had enough

Cable from this era was often insulated with rubber, which hardens and crumbles over time, particularly in a hot roof space. Faults show up as lights that flicker when a door slams, a circuit that trips only in summer, or switches that feel warm. An insulation resistance test shows how far the breakdown has gone. Where only one circuit is affected, replacing it may be enough; where several fail, you get a clear written picture before deciding on a rewire. Plenty of older Parkdale homes are in exactly this position.

FAQ

Common questions

I'm about to renovate. Should I have a fault looked at first?

Yes. If testing shows the wiring is breaking down, it is far easier to replace while walls and ceilings are open. Finding it first also means the fault is not blamed on the renovation later.

Is a flickering light always a wiring fault?

No. It can be a failing lamp, a dimmer that does not suit LED globes, or a loose lamp holder. If the flicker affects several lights, or happens when appliances start, the wiring or a connection is more likely and worth testing.

Book a free on-site quote

Call EricFree quote