Skip to content
Zap Electrical & Data

Split System Installation · Parkdale

Split System Installation in Parkdale

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Many Parkdale homes date from the 1950s and 60s, and their original fuse boards were never meant for air conditioning. On the smaller blocks near the beach, owners also tend to build upward, which creates new bedrooms under the roof that need cooling. Shopfronts on Como Parade, a few with living quarters upstairs, bring their own wiring puzzles. Before recommending a unit, we look at the board, the walls outside and what the building has been through.

About our split system installs service

Planning for a second storey

If you are adding a level, the cheapest time to plan air conditioning is during the build. Pipework and cable can run through the new frame to a condenser at ground level or on a bracket, and the circuits go into the new or upgraded switchboard that a second storey usually needs anyway.

Bedrooms upstairs take more sun on the roof and walls, so they often need slightly more capacity than similar rooms below. We coordinate with your builder so nothing has to be chased into the walls after the plaster goes on.

Fuse boards and shared shop wiring

A mid-century home still on rewireable fuses needs a board with circuit breakers and RCD protection before a new circuit goes in, and that work usually comes first in the quote. Along the shopping strip, older buildings sometimes have a shop and an upstairs flat sharing a board.

Adding air conditioning to either is a good time to separate the two, so the unit is on the right tenancy's supply and a fault downstairs doesn't cut the flat's cooling. We trace the circuits before quoting, and landlords get a clear written split of costs.

FAQ

Common questions

My house has original wiring. Can I still add air conditioning?

Usually, once the switchboard is brought up to date. The new unit runs on its own new circuit, so it doesn't rely on the old cabling. We do test the existing wiring while we're there and tell you if anything else needs attention.

Where should the outdoor unit go on a small block?

Side passages and rear courtyards are the usual spots. We look for a position with airflow around the unit, a short pipe run and some distance from a neighbour's bedroom window, so it can run at night without disturbing anyone.

Book a free on-site quote

Call EricFree quote