Skip to content
Zap Electrical & Data

Electrical Fault Finding · Mordialloc

Electrical Fault Finding in Mordialloc

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

A blown ceramic fuse in a post-war weatherboard and a safety switch that drops halfway through lunch service in a Mordialloc cafe kitchen look like different problems, but both start the same way: work out what was running, which device let go, and then test that circuit by itself. Eric is based ten minutes away in Aspendale Gardens and does the testing himself, so the person who finds the cause is the same person who explains it and quotes the repair.

About our electrical fault finding service

Old fuse panels that keep blowing

Plenty of homes near the Nepean Highway still protect their circuits with rewireable fuses. When one keeps blowing, the temptation is to fit heavier fuse wire, which removes the only protection that circuit has.

The usual causes are simpler and safer to fix: a heater and kettle sharing one old circuit, a loose terminal in the panel that heats up under load, or a cracked rubber-insulated cable inside a wall. An insulation resistance test tells us whether the cable itself is breaking down. If it is, you see the reading and get written options before anything is replaced.

Cafe and restaurant kitchens

Commercial kitchens are hard on circuits. Fryers, combi ovens, glass washers and dishwashers all have heating elements, and an element that has started to break down leaks a little current to earth, sometimes only once it is hot. Add steam and grease around outlets and you get an RCD that trips at the busiest hour.

We test each appliance on its own, check outlets and isolators near wash areas for moisture, and schedule testing before trading starts so the kitchen is not shut down mid-service. Older shop boards along the Mordialloc strip may also be near capacity, which we check at the same time.

FAQ

Common questions

My outdoor lights near the beach keep tripping the power. Why?

Salt air corrodes the terminals and seals on outdoor fittings, and once a seal fails, moisture gets in and leaks current to earth. We open and test each fitting on the circuit, replace the ones that have corroded with coastal-rated gear, and reseal cable entries.

Can you test a single appliance I suspect is faulty?

Yes. Plugging it in on a known good circuit and testing its insulation shows whether it is leaking. If the appliance is the problem, we tell you so you can repair or replace it, rather than spending money on the wiring.

Book a free on-site quote

Call EricFree quote