Skip to content
Zap Electrical & Data

Local electrician · Seaford

Electrician in Seaford

Seaford sits between the Kananook Creek and the bay, with a mix of homes and a busy light-industrial area.

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

We look after homeowners and businesses here, from fuse box replacements to factory unit maintenance.

Where we work in Seaford

We work along the Nepean Highway strip, the streets near Seaford station and the Seaford Wetlands, and the industrial estates towards Carrum Downs.

Homes and buildings

Plenty of older weatherboards and brick homes still run on original switchboards. Coastal moisture is a common cause of faults in outdoor circuits.

Workshops and trade businesses

The suburb's industrial streets are full of mechanics, fabricators, joiners and trade suppliers, and their power needs grow with the business. Common jobs include 32-amp three-phase outlets for welders and compressors, extra circuits along workbenches, and replacing tired fluorescent battens with LED high-bays so the workshop is properly lit.

Older units may also have switchboards that need more capacity or better protection. We start early in the day where possible, so the workshop can get back to business quickly. Where a business expands into the unit next door, we can extend circuits across, add a second sub-board and make sure emergency lighting covers the new floor area.

Foreshore homes and the dunes

Homes on the beach side of the highway face onshore winds that carry salt and fine sand across the dunes. Over time this corrodes meter boxes, outdoor powerpoints, sensor lights and the screws holding them on, and corrosion inside a meter box can loosen connections.

We inspect external fittings, replace corroded meter boxes and outdoor gear with marine-grade or suitably rated products, and seal cable entries so salt and sand stay out. Checking these every few years costs far less than replacing a fitting after it fails. Stainless screws and sealed glands make a noticeable difference this close to the water.

Weatherboards on stumps

Many of the older weatherboard homes near the station sit on stumps with a crawl space underneath. That makes rewiring more practical than in a slab-floored home, because new cables can run through the subfloor and up into the walls with little disturbance.

When owners restump or replace floors, it is an ideal time to replace old cabling under the house, which can be damaged by moisture or vermin. We coordinate with the restumping crew so new cabling is clipped clear and protected. Any wiring left in the walls is tested, so you know whether it can stay.

Free quote

Request a free quote

  • Free on-site quote

    Eric comes out, looks at the job and gives you a clear written quote.

  • No call-out fee on quoted work

    You only pay for the work you approve.

  • We aim to call back within the hour

    During business hours, Mon–Fri 7:00am–5:00pm.

  • 12-month workmanship warranty

    Fully licensed and insured. REC 23657.

Eric Felices

The person who quotes your job
is the person who does it.

Prefer to talk? 0400 364 638

FAQ

Common questions

Do you replace old fuse boxes in Seaford?

Yes. We replace them with modern switchboards and safety switches.

Do you service Seaford businesses?

Yes, including shops, workshops and industrial units.

Can you install a welder outlet in my workshop?

Yes. We check the welder's rating and your supply, then install a suitably rated single or three-phase outlet on its own circuit with the correct protection. If the workshop needs several outlets, we look at a sub-board so the main board is not overloaded. A lockable isolator can also stop the welder being used without permission.

My meter box is rusty. Does it need replacing?

If the box is corroded through, the door no longer seals or the backing panel is damaged, replacement is worth doing. We check the condition of the connections inside and fit a box suited to coastal exposure. Meter box work may involve the distributor, which we organise for you.

Is it a good idea to rewire while restumping?

Yes. With the subfloor open and accessible, cables under the house can be replaced easily. We arrange timing with your restumper so the wiring is done before the floors go back down. It also lets us find old joins and redundant cables hidden under the floor and remove them.

Nearby areas

Call EricFree quote