Skip to content
Zap Electrical & Data

Office Fit-outs · Parkdale

Office Fit-outs in Parkdale

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Parkdale's commercial space is concentrated around Como Parade and the station, in older shop buildings that often include a flat or rooms upstairs. Those upper rooms are increasingly leased as offices, and the shops below are refitted for practices and services. Wiring in buildings of this age has usually been altered many times. Eric traces what feeds each part of the building, separates tenancies where needed, and quotes the new office layout clearly before anything is opened up.

About our office fit-outs service

Turning the upstairs flat into an office

A flat above a shop was wired as a home: a few outlets per room, a kitchen circuit and perhaps a shared board with the shop. Used as an office, it needs outlets and data at each desk, lighting suited to screen work, and attention to the stair and exit path.

If the office is leased separately, its own board and protection mean a fault downstairs no longer cuts power upstairs, and separate metering can be arranged with the owner. Cable routes up the building are planned so nothing is left exposed on the staircase.

Old shop boards and new equipment

Some shop switchboards along the parade still have rewireable fuses, limited safety switch protection and no spare space. A refit that adds computers, a kitchenette, heating and cooling can push one past its limit. We test the existing circuits, check the incoming supply, and recommend a new board where the old one cannot be extended safely.

Old cable is replaced where it fails insulation or earthing tests, rather than being left in the ceiling. Planning this before the builder lines the walls avoids paying to open them again, and the new board is labelled tenancy by tenancy.

FAQ

Common questions

Do I need emergency lighting for a small upstairs office?

It depends on the building and the layout. Requirements come from the building code and how the building is classified, and stairs are often where it matters most. We look at the exit path, advise what applies, then install and log any fittings needed.

Can the shop trade while the upstairs is fitted out?

Usually. Most work happens upstairs and in the ceiling, and shutdowns to connect new circuits are booked for before opening. Both tenants hear ahead of time about each shutdown and roughly how long it lasts.

Book a free on-site quote

Call EricFree quote