Skip to content
Zap Electrical & Data

Switchboard Upgrades · Waterways

Switchboard Upgrades in Waterways

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Waterways homes date from the early 2000s, so very few need a switchboard replaced for safety reasons alone. What they often need is more protection and more room. Boards from that era typically have one or two safety switches that don't cover every circuit, and little spare space to fit an EV charger, pool pump or outdoor kitchen circuit. With our base just around the corner in Aspendale Gardens, Eric can look at the board and tell you straight whether to add to it or replace it.

About our switchboard upgrades service

Adding RCBOs instead of replacing

If the enclosure is in good order and has room, unprotected circuits can often be fitted with RCBOs, which combine a breaker and a safety switch in one device. That brings the board in line with current expectations for less than a full changeover.

Where the board is already full, a larger enclosure may still be the better choice, especially if more additions are planned. We explain both options and price whichever suits. Either way, every circuit is tested afterwards and the labels are brought up to date. Older RCDs are tested as well.

Lakefront and outdoor loads

Houses facing the lakes tend to have decks, alfresco kitchens, garden lighting and sometimes spa or pool equipment, all working outdoors in damp air. Those circuits should each have their own protection, so a wet fitting by the water does not trip the kitchen inside.

When we rearrange or replace a board, outdoor circuits are separated and clearly labelled, and weatherproof isolators are fitted at the equipment where needed. We also check outdoor outlets for moisture, since water getting in is a frequent cause of trips. Sealed, properly rated fittings make a real difference by the lakes.

FAQ

Common questions

Can my 2000s board handle an EV charger?

Often it can, if there is a spare position and the supply has capacity. We check the main cable, the existing demand and the space on the board, then tell you whether a dedicated circuit is enough or more work is needed.

Why does the safety switch trip when the dishwasher runs?

It may be a fault in the appliance, a damaged cable, or too many circuits sharing one RCD so that small leakages add up. We test the circuits and the appliance to find the cause before suggesting any change to the board.

Book a free on-site quote

Call EricFree quote