Skip to content
Zap Electrical & Data

Switchboard Upgrades · Heatherton

Switchboard Upgrades in Heatherton

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Plenty of Heatherton properties have a switchboard that grew outward with the land. A circuit went to the shed, another to a bungalow, then a pump, a cool room or a granny flat, each one squeezed into whatever space was left. Some of those runs have no safety switch at all. Eric traces where each circuit goes, tests the long underground feeds, and designs a board and any sub-boards so every building on the property is properly protected.

About our switchboard upgrades service

Sub-boards for outbuildings

Once a shed or workshop has several lights, power points and a machine or two, it should be fed by a correctly sized submain to its own sub-board rather than a single circuit from the house. That gives the outbuilding local RCD protection, an isolator close at hand and room for additions.

Granny flats need the same approach, sized for their heating, cooling and kitchen. Older feeds trenched without conduit or warning tape are tested before reuse, and replaced if the results are poor. Long runs are sized so voltage drop stays within limits.

Nurseries and landscape yards

Across the green wedge, commercial growers and landscape suppliers depend on irrigation pumps, cool rooms and workshop gear, often from a board that has been added to for decades.

A replacement is planned around the business: which loads cannot be off for long, whether three-phase is available, and where sub-boards should sit so pumps and cool rooms have their own protected circuits. We schedule the changeover for a quiet part of the week and label every circuit to match what it actually feeds. Generator inlets for pumps can be added too.

FAQ

Common questions

Do I need a new board to add a granny flat?

Not always, but most older boards have no spare capacity for a dwelling with its own heating, cooling and kitchen. We calculate the extra load, check the supply and recommend either a submain with a sub-board or a full replacement.

Why does my shed circuit trip when it rains?

Water in an outdoor outlet, a buried joint or a damaged cable is the usual cause, and the safety switch is doing its job. We test the circuit to find the fault, repair it and make sure the feed is properly protected.

Book a free on-site quote

Call EricFree quote