Skip to content
Zap Electrical & Data

Residential Electrician · Brighton

Residential Electrician in Brighton

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

A large renovation in Brighton is rarely a single trade's job. Builders, designers, lighting consultants and pool, security and automation suppliers all need the electrical side in place at the right moment. Victorian and Edwardian homes add another layer, with original circuits buried under generations of additions and fittings worth keeping. Eric works from your architectural and lighting drawings, meets the builder on site, and stays your one contact from the first walk-through to the Certificate of Electrical Safety.

About our residential electrician service

Coordinating with the building team

On a substantial job the electrical work happens in stages. Before frame stage the load is estimated and any supply upgrade lodged with the distributor, since induction cooking, ducted systems, pool heating and more than one car charger can outgrow single phase.

At rough-in every point is walked against the plans with you or the designer. Cabling for gate motors, intercoms, cameras and garden lighting goes in at the same time, so nothing has to be chased into finished walls. Fit-off follows painting, and the board is labelled circuit by circuit.

Old fittings and decades of additions

In a Victorian or Edwardian home, the wiring can tell several stories at once: an original run in the roof, a 1960s kitchen circuit, a later extension tied in wherever was easiest. Everything is tested before the quote is finalised, so you know what is safe to keep.

Ceiling roses, period switches and heritage pendants can usually stay, rewired behind and connected to a protected circuit. Where cornices and decorative plaster matter, routes are chosen through roof and floor so the rooms are left as they were. Switches and sockets can also be chosen to suit the period of the house.

FAQ

Common questions

Will a new home need three-phase power?

Possibly. It depends on the total load from heating, cooling, cooking, pool equipment and EV charging. Eric works it out from your plans early, before the supply application is due.

Can you wire for home automation?

Yes. We run the cabling, data and switching your automation installer specifies, and leave the switchboard laid out and labelled so future changes are straightforward. Spare conduit to key rooms makes later upgrades easier.

Book a free on-site quote

Call EricFree quote