Skip to content
Zap Electrical & Data

Electrical Fault Finding · Brighton

Electrical Fault Finding in Brighton

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

A large Brighton home can have a main switchboard, two or three sub-boards, garden lighting across a deep block, gate motors, an intercom and pool equipment. When something trips in a house like that, the hardest part is often knowing which board, which circuit and which building it belongs to. Eric starts by mapping what each protective device actually feeds, then narrows the fault down step by step. The findings are explained on site and any repair is quoted in writing.

About our electrical fault finding service

Sub-boards, gates and garden circuits

Outdoor equipment on big blocks sits in weather and in garden beds. Gate motors, intercom panels and inground uplights all take in water over time, and their cables run underground where irrigation, roots and landscaping work can reach them.

A fault there can trip a safety switch inside the house or on a sub-board in the pool house. We test each outdoor run on its own, check fittings and junction pits for water, and tell you whether the repair is a sealed fitting, a new length of cable or new equipment.

When automation hides the fault

Newer homes with lighting control, motorised blinds and smart switches add a layer between the wall switch and the light. A light that will not come on may be an electrical fault, a failed module or a programming problem. We test the power side first: supply to the controller, circuit protection and the fitting itself.

If the wiring and supply test sound, we tell you so in writing, so your automation installer starts from a known point instead of guessing. Drivers and power supplies for low-voltage lighting are tested in the same visit, since they fail more often than the fittings.

FAQ

Common questions

Our clinic on Church Street loses power to one room. Can you come before appointments?

Yes, work can start at 7am. We test the affected circuits first, keep the rest of the rooms powered where possible, and give you a written report of what failed and what was repaired.

Will you work around original features in a period home?

Yes. Ceiling roses, cornices and original switches are tested in place where possible. If a fitting is the source of the fault, we explain whether it can be repaired and rewired before suggesting a replacement.

Book a free on-site quote

Call EricFree quote