Skip to content
Zap Electrical & Data

Switchboard Upgrades · Skye

Switchboard Upgrades in Skye

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Recent estate homes around Ballarto Road usually have a modern board with circuit breakers and RCDs, so the question in Skye is rarely about safety basics. It is about room. Builders install a board sized for the base plan, and once a family adds an alfresco heater, a garage gym, a split system or two and an EV charger, there are no positions left. An upgrade here usually means a larger enclosure, more RCD capacity and spare space for what comes next.

About our switchboard upgrades service

When the builder's board is full

A full board leads to circuits being doubled up on one breaker or squeezed in without proper RCD coverage. The better fix is an enclosure with room to spare, with circuits spread over several RCDs so a fault in the alfresco heater does not also kill the kitchen.

Before quoting, the household's maximum demand is worked out against the single-phase supply, because adding circuits does not add capacity at the street. Where it is tight, a car charger with load management can keep the main switch from tripping on a busy evening.

Sheds and acreage on the edges

Out on the larger semi-rural blocks, sheds, pumps and workshops are often fed from the house board by long cables, or from an old private line. Fitting a small distribution board at the shed, complete with RCDs and a local main switch, lets the building be isolated on its own and keeps faults out there from tripping the house.

The feed is sized for the distance, laid at the burial depth set by the Wiring Rules and routed around tanks, septic lines and fences. The main board is then laid out to suit.

FAQ

Common questions

Should I add space for solar or a battery now?

If either is likely within a few years, yes. Spare positions and room for extra protection devices cost little when the enclosure is new, and they save replacing a cramped board again once the panels or battery arrive.

My board is only a few years old. Why would it need upgrading?

Age is not the issue. Capacity and layout are. If every position is used and new circuits are being piggybacked, a larger board keeps each circuit properly protected and leaves room for the next addition.

Book a free on-site quote

Call EricFree quote