Skip to content
Zap Electrical & Data

Electrical Fault Finding · Mount Martha

Electrical Fault Finding in Mount Martha

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Faults in a weekender have a way of happening while nobody is there. The owners arrive to a dark house, a tripped switch and a fridge that has been off for days, with no idea what set it off. Eric's job is to work out what tripped and why, even when the fault has gone quiet. Testing each circuit's insulation, checking outdoor equipment and asking what changed since the last visit usually reveals the cause, and the fix is then quoted in writing.

About our electrical fault finding service

When nobody saw it happen

Without anyone present, the usual clues are missing: which appliance was running, whether it was raining, whether the lights flickered first. So we rely on testing. Every circuit on the tripped safety switch gets an insulation resistance reading, outdoor fittings are opened and checked for water, and appliances left plugged in are tested on their own.

A storm, a leaking gutter over an outdoor light or a fridge compressor on its way out are frequent findings in houses here that sit empty between visits. Gutters and downpipes near outdoor fittings are worth a look too, since overflow often drips straight onto them.

Pumps, irrigation and garden circuits

Inland blocks towards The Briars often run rainwater tank pumps, irrigation controllers and power to a garden shed, all exposed to weather and garden work. A pressure pump that cycles all night because of a leak in the pipework will eventually wear its motor and start leaking current to earth.

Irrigation controllers mounted outside suffer from water and ants. We test the pump and its circuit separately, check the isolator for moisture, and make sure the pump can be switched off without taking the rest of the house down with it.

FAQ

Common questions

Can you find a fault that only happened while we were away?

Often, yes. Faults that trip a safety switch usually leave something measurable behind, such as low insulation readings, water in a fitting or a faulty appliance. If nothing shows on the day, we tell you what we tested and what to note if it happens again.

Every time the tank pump starts, the lights flicker. Is that a fault?

A brief dip as a motor starts can be normal on a long or shared circuit. If it is getting worse, or the pump hums without starting, the motor or its capacitor may be failing, or a connection may be loose. We measure the voltage while it starts to tell which.

Book a free on-site quote

Call EricFree quote