Skip to content
Zap Electrical & Data

Switchboard Upgrades · Frankston South

Switchboard Upgrades in Frankston South

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Homes in Frankston South were largely built between the 1960s and 1990s, and many have been extended as owners stayed on. Each addition tended to bring a few more circuits, sometimes a small sub-board in the garage or lower level, while the main board stayed as it was. The result is protection spread unevenly through the house. Eric maps every board and circuit before quoting, then consolidates them into a layout where each part of the home is protected and labelled.

About our switchboard upgrades service

Boards in split-level homes

On the slopes around Olivers Hill and Sweetwater Creek, the switchboard often sits in a garage or under-house level, with long runs up to the bedrooms. Damp lower floors can corrode terminals and enclosures, so we check for moisture and choose a suitable enclosure if the board stays put.

Where several old sub-boards exist, some can be removed by bringing their circuits back to the new main board; others are better kept and fitted with their own RCDs. We explain the trade-off for your particular house. Labels are written for each level.

What the roof space can reveal

Bushy streets bring possums and rats, and both chew cable. When a new board's RCDs are switched on, damaged insulation that went unnoticed under old fuses can trip them immediately. That is why each circuit is tested before connection. If we find chewed or heat-damaged cable, we show you where it is and quote the repair before going any further.

Sorting out the animals before new cable goes in avoids paying for the same repair twice. Old cable gone brittle from roof heat shows up in the same tests, and the readings are shared with you so you can see exactly which circuits passed.

FAQ

Common questions

Can the board stay where it is during a renovation?

Usually, yes. If the renovation adds a lot of load, such as a new kitchen and ducted cooling, we check the main cable and enclosure can carry it. Moving the board is possible but involves the mains and sometimes the distributor, so it is quoted separately.

Do bush blocks need anything different at the board?

The board follows the same rules, but outdoor circuits on treed blocks deserve attention: sealed fittings, protected cable joins and safety switches you test regularly. Giving outdoor circuits their own protection also stops a wet garden light tripping the whole house.

Book a free on-site quote

Call EricFree quote