Skip to content
Zap Electrical & Data

Commercial Electrician · Carrum Downs

Commercial Electrician in Carrum Downs

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

The suburb's industrial estates, reached from Frankston-Dandenong Road, Hall Road and Ballarto Road, hold a dense mix of factory units, warehouses and trade businesses, many of them in strata complexes. That makes Carrum Downs a suburb where commercial electrical work is mostly about keeping production running: new machine circuits, lighting, switchboard capacity and compliance testing. Eric quotes each job after walking the site, and the person who quotes is the person who does the work, from first visit to sign-off.

About our commercial electrician service

Moving into or out of a factory unit

Units in the estates change occupants regularly, and each move has an electrical side. An incoming business needs to know whether the existing board and supply can run its equipment, where the three-phase outlets are, and whether the emergency lighting logbook is current.

An outgoing tenant may owe make-good: removing machine circuits, capping redundant cabling and returning the lighting to its original layout. We inspect, test and document the installation at either end of a lease, then quote the changes item by item, giving landlord and tenant the same written picture to negotiate from.

Charging for vans and fleet vehicles

Trade businesses are starting to run electric utes and vans, and charging them overnight at the unit is the obvious answer. The catch is supply: a factory unit already running compressors and machinery may have limited headroom left. We measure the existing load, size chargers to suit, and use load management so charging slows when the workshop is busy and picks up after hours.

Chargers are mounted clear of forklift and vehicle paths, protected against impact where needed, and wired on their own circuits. In a strata complex, any charger installed on common property has to be approved by the owners corporation first.

FAQ

Common questions

Can you work while the factory keeps running?

Most of the time, yes. Circuits feeding critical machines are identified first, and any shutdown is limited to one section or booked for an early start. Staff are told beforehand which areas lose power and when.

Do you replace metal halide high-bays with LED?

Yes. LED high-bays start instantly, use far less power and pair well with motion sensors in aisles and storage areas. We check mounting heights, light levels for the tasks below and any emergency lighting that needs relocating at the same time.

Book a free on-site quote

Call EricFree quote