Skip to content
Zap Electrical & Data

Data Cabling & Networking · Braeside

Data Cabling & Networking in Braeside

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Braeside warehouses and factory units around Woodlands Drive and Lower Dandenong Road usually have a two-storey office at the front and a high-roofed floor behind it, and the network has to serve both.

We install comms racks, office outlets, high-level access points for scanners, and camera cabling for docks and yards, working to your site induction and keeping our area fenced off. Every run is tested and labelled. Eric quotes the job on site and does the work himself, so the person who planned the routes is the person installing them.

About our data cabling & networking service

High roofs and long floors

In a tilt-up building, cable to the warehouse floor runs on tray or catenary wire up near the roof, then drops to outlets on columns or to access points mounted above the racking. We bring a suitable elevated work platform and plan around forklift traffic.

Large floors can exceed the 90 metre limit from a single cabinet, so a second cabinet partway along the building, linked back to the office, is sometimes the right design. Cable is supported on its own fixings rather than laid over the lighting, so it doesn't sag across aisles or get damaged when high-bays are serviced.

Before racking goes in

A new tenancy is the best time to get the network right. With the floor empty, we can run cable where dispatch benches, offices and cameras will sit, and avoid routes that racking or mezzanines will later block. Many 1980s and 90s units still carry old phone cabling and patchy outlets in the front office, which we remove and replace with a labelled Cat6 installation.

We also allow points for the boardroom screen, the reception desk and any access control at the front door, and leave spare ports for the next stage of growth. A labelled schedule goes to your IT provider at handover.

FAQ

Common questions

Can access points be mounted in the warehouse roof?

Yes, though too high hurts coverage at floor level. We usually mount them on purlins or columns above the racking, aimed down the aisles, with one cable supplying both power and data.

Will the work interrupt our network?

New cabling goes in alongside the old. The changeover to the new rack is the only interruption, and we schedule it with your IT provider for an early start or a quiet period.

Book a free on-site quote

Call EricFree quote