Skip to content
Zap Electrical & Data

EV Charger Installation · Moorabbin

EV Charger Installation in Moorabbin

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

The suburb is mainly commercial, so charging here usually means business premises. Dealerships on the Nepean Highway need power for stock and demonstrator vehicles, factory units off South Road are adding electric vans, and offices near the airport want a few staff bays. Each site already has a working load, so the starting point is always what the switchboard and supply can spare. Eric surveys the site and gives you an itemised written quote.

About our ev charger installation service

Showrooms and car yards

A dealership selling electric models has to keep stock topped up and demonstrators ready to drive, which means chargers at several points across the yard, workshop and delivery bay. These sites often run three-phase supply with large existing loads from lighting, signage and the service department.

We look at peak demand, then suggest a mix of wall units and pedestals, with load management so charging never trips the main supply. Pedestals in an open yard need bollard protection and cable under paving, so we plan conduit with your builder if resurfacing is coming up.

Factory units and the airport business parks

In a typical factory unit with a front office, two or three chargers near the roller door or in the staff car park are usually enough to start. The board may already be busy with compressors, welders or air conditioning, so we measure actual demand rather than guess.

Chargers with RFID cards or app access keep fleet charging separate from staff use, and usage reports simplify reimbursement. If you lease, the landlord normally needs to approve the work, and we can provide a written scope to send them. Wall-mounted chargers on the building are generally simpler to install than pedestals in open bays.

FAQ

Common questions

Do you install chargers at Moorabbin homes as well?

Yes. Post-war houses and newer townhouses get the same assessment: board condition, spare capacity and the cable route to the garage or carport. Older boards with ceramic fuses usually need replacing before a charger goes in.

Can chargers be added in stages as our fleet grows?

Yes. We size the submain and run conduit to future bays during the first stage, so each new unit becomes a smaller job. Load management can be set up to accept additional chargers without redesigning the system.

Book a free on-site quote

Call EricFree quote