Skip to content
Zap Electrical & Data

Split System Installation · Hampton

Split System Installation in Hampton

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Period homes in Hampton reward a careful approach to air conditioning. Edwardian villas, bungalows from the 1920s and brick homes from between the wars have decorative ceilings, picture rails and street-facing facades that owners want left alone, while roof spaces and subfloors can be tight to work in.

A good install keeps pipework out of sight, puts the indoor unit where it does not fight with original features, and keeps the outdoor unit off the front of the house. Eric works through those choices with you at the free on-site quote.

About our split system installs service

Keeping the character intact

In a room with high ceilings and ornate cornices, a wall-mounted unit can look out of place above a picture rail. A floor console unit, set low on an inside wall, often sits better in a period lounge and suits heating well, since warm air starts at floor level.

Pipework can usually travel under the floor to a rear or side wall, where the outdoor unit sits out of view. If underfloor access is too tight, we talk through a roof route or neat external ducting along a side wall before deciding.

Rebuilds and homes near the water

Large contemporary homes often have high-glass living areas facing north or west that need more capacity than their floor area suggests, and sometimes more than one unit to cover an open-plan space evenly. Closer to Beach Road, salt air attacks outdoor coils, fixings and isolators, so we use a sheltered position where possible, a corrosion-protected unit and stainless fixings.

Each unit runs on its own circuit from a board with RCD protection, and an older board may need upgrading first. We check the board at the quote, so any upgrade is priced up front.

FAQ

Common questions

Does the install mean cutting into old lath and plaster?

Rarely. The pipe and cable for a single unit pass through one hole in the wall behind the indoor unit, and the electrical feed can usually come through the roof space or subfloor. If a wall has to be opened, we tell you before work starts.

Can you take out an old wall unit at the same time?

Yes. We disconnect and remove it, reuse the existing penetration if it suits the new position, and list removal and disposal separately on the quote. Old refrigerant is recovered rather than released.

Book a free on-site quote

Call EricFree quote