Skip to content
Zap Electrical & Data

Residential Electrician · Frankston

Residential Electrician in Frankston

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Frankston covers a lot of ground, from post-war houses and units in the streets east of the city centre to larger homes on sloping, tree-lined blocks heading towards Frankston South. Household electrical work follows that spread. Units tend to need small, careful upgrades within tight spaces, while hillside homes need power and lighting carried a long way from the house. We are about twenty minutes from Aspendale Gardens, and the quote visit costs nothing.

About our residential electrician service

Units and smaller post-war houses

Units from the 1960s and 70s often have a compact switchboard in the kitchen or hallway, rewireable fuses and very few outlets. Owners updating them want a modern kitchen, a split system and somewhere to charge devices without power boards.

We swap the old fuses for a board with circuit breakers and RCDs, add circuits for new appliances, and replace old switches and outlets throughout. Where work touches the meter panel or common property, we let you know so the owners corporation can approve it first. Post-war houses nearby need much the same, usually starting with the switchboard.

Long cable runs on sloping blocks

On hillside blocks, sheds, pool equipment and garden lighting can sit well down the slope from the house. A long run needs cable sized for the distance as well as the load, or the voltage sags and motors struggle.

We dig the trench clear of tree roots and drainage, run cable in conduit at the required depth, and fit a sub-board at the shed if it needs several circuits. Steps and paths get low-glare lighting on a timer or sensor, so the garden is safe after dark. After strong winds, check that branches aren't touching the overhead service line.

FAQ

Common questions

Why do power tools slow down in my shed at the bottom of the yard?

Usually voltage drop: the cable to the shed is too small for the distance and the load. We measure it under load and, if needed, run heavier cable or a sub-main to a small board in the shed.

Can you replace an oven or wall heater in an older unit?

Yes. We check the existing circuit's rating against the new appliance, upgrade the cable or breaker if needed, and connect it. Older units sometimes have ovens on undersized circuits, which we will point out before installation.

Book a free on-site quote

Call EricFree quote