Skip to content
Zap Electrical & Data

LED & Feature Lighting · Aspendale

LED & Feature Lighting in Aspendale

  • Free on-site quote
  • No call-out fee on quoted work
  • 12-month workmanship warranty
  • REC 23657

Between the foreshore and the train line, Aspendale has a mix of original beach houses and large knock-down rebuilds, and the lighting each needs is quite different. A rebuild can have every pendant, strip and garden light designed from the drawings, while an older cottage usually wants its halogens and tired outdoor fittings replaced without disturbing much else. Salt carried off the bay shortens the life of anything outside, so fittings are chosen for that exposure first and looks second.

About our led & feature lighting service

Planning lighting for a rebuild

A new house gives you the chance to light it in layers from day one. Conduit for garden and path lighting can go in before the landscaping, the driveway or the slab, which saves trenching through finished paving later.

Inside, strip lighting in the kitchen and robes needs driver positions agreed with the cabinetmaker before the joinery is made, and pendant heights over the island are best confirmed on site. A facade washed with light from the ground looks far better than a single floodlight on the eave, and it can run on a dusk sensor or timer.

Outdoor showers, decks and salt air

Beach-side houses end up with lights in exposed spots: over the outdoor shower, along deck edges and beside the side gate where boards and wetsuits are rinsed. Each of those needs an IP rating to suit direct water, a housing that will not corrode within a few seasons, and safety switch protection on the circuit.

Low-voltage step and deck lights are safe underfoot and easy to replace one at a time. We seal cable entries, use stainless fixings and place drivers somewhere dry, because a corroded driver is usually what takes outdoor lighting out first.

FAQ

Common questions

My cottage has old dimmers. Will they work with LED downlights?

Often not well. Dimmers designed for halogen or incandescent lamps can make LEDs flicker, hum or stop short of a smooth fade. We replace them with dimmers matched to the new drivers, and test every circuit at low settings before we leave.

Can you install lighting an architect or builder has specified?

Yes. We work from the lighting plan, point out fittings that would be awkward to reach or service, and confirm positions on site with you before fit-off. Fittings you buy yourself are fine, provided each one is legal for sale here and suits its location.

Book a free on-site quote

Call EricFree quote